Jacuzzi J-200 - 11.8 Preferences

J-200
11.8 Preferences
This menu allows you select certain display preferences.
A. Setting the temperature display
1. From the Main Menu, press the button until you reach “PREF.”
2. Press or to enter the menu. The display will show “F/C.”
3. Pressing or will toggle between °F or °C.
4. Once you make your selection, press the button to accept the
change.
B. Setting the time display
1. From the Main Menu, press the button until you reach “PREF.”
2. Press or to enter the “F/C” menu. Then press the button
to enter the time display menu “24-12.”
3. Pressing or will toggle between “24HR” and “12HR.”
4. Once you make your selection, press the button to accept the
change.
C. Reminders
Your spa is equipped with 3 reminders.
• Change Water occurs every 125 days, page 51.
• Change Filter occurs every 180 days, page 52.
• Change UV Bulb occurs every 365 days, page 52.
1. From the Main Menu, press the button until you reach “PREF.”
2. Press or to enter the menu. Then press the button
until you get to the “REMINDERS” display.
3. Press or to select and toggle between “YES” and “NO.”
4. Once you make your selection, press the button to accept the
change.
5. Once the timer expires and the reminder appears on the display,
press or to reset the timer.
D. Cleanup Cycle Duration
1. From the Main Menu, press the button until you reach “PREF.”
2. Press or to enter the menu. Then press the button
until you get to the “CLN UP” display.
3. Press or to move through the duration’s settings of 0.5H up to
4.0H, in increments of 30 minutes.
4. Once you make your selection, press the button to accept the
change and revert back to the “PREF” Menu.
E. Poll Cycles Duration - Ready Mode Only
(In order to maintain a constant water temperature, heat as needed, and
refresh the temperature display the pumps actives to circulate the water.
This is known as “polling.” Default setting is ON.)
38