Jacuzzi J-200 - D. Sensor Related Messages; E. Miscellaneous Messages; F. System Related Messages

J-200
D. Sensor Related Messages
1.
Sensor Balance is Poor - M015: The temperature sensors may be
out of sync by or 3°F (1.5°C). Call for Service.
2.
Sensor Balance is Poor - M026: The temperature sensors are out of
sync. The Sensor Balance is Poor fault has been established for at
least 1 hour. Call for Service. The message can be reset by pressing
any button.
3.
Sensor Failure - Sensor A: M031, Sensor B: M028: A temperature
sensor or sensor circuit has failed. Call for Service.
E. Miscellaneous Messages
1.
No Communications: The control panel is not receiving
communication from the system. Call for Service.
2.
°F or °C is replace by °T: The Control System is in Test Mode. Call
for Service.
F. System Related Messages
1.
Memory Failure - Checksum Error - M022: At power up, the system
has failed the Program Checksum test. This indicates a problem with
the rmware (operation program) and requires a service call.
2.
Memory Warning - Persistent Memory Reset - M021: Appears
after any system setup change. Contact your dealer or service
organization if this message appears on more than one power up or
it if appears after the system has been running normally for a period
of time.
3.
Conguration Error - Spa will not Start up: Contact your dealer or
service organization.
4.
GFCI Failure - System Could Not Test/Trip the GFCI - M036: NORTH
AMERICA ONLY. May indicate an unsafe installation. Contact your
dealer or service organization.
53