30
Press again
Solid Colour Mode:
Selects one of 7 solid colours of choice.
Pressing the button again will make the sequence starts
from the beginning.
Jets
The water ow through individual jets in your spa can be
adjusted or turned o by rotating the outside jet ring. Some jets
oer an adjustable center nozzle that allows you to change the
water discharge angle. Simply tilt the center nozzle in these jets
to the desired angle to customize your personal massage. Other
jets oer a spiral action that produces a surging stream of air
and water that provides a vigorous massage.
Note: Always keep at least 6 adjustable jets open at all times to en-
sure proper ltration characteristics within the spa.
Selecting Desired Massage Action
CB
A
All models incorporate a massage selector valve that
allows you to customize the massage and performance by di-
verting water between various jet systems within the spa. Sim-
ply turn valve to positions A, B or C to divert water pressure to
various jet groups.
Note: The valve is intended to operate in positions A (Combo), B,
or C for optimum performance. It is considered normal for sound
levels within the valve to increase between these positions due to
the large amounts of water owing through it. For optimum ltra-
tion benets, always leave this valve in position A when the spa is
covered and select positions B or C for maximum jet performance
during spa use.
Waterfall Feature
The waterfall feature allows you to independently control it for a
customized soothing eect. The waterfall is on when the circu-
lation pump is on. The JETS 1 (
) or CLEARRAY ( ) buttons
will also activate the waterfall feature.
Waterfall Operation Details:
A. Push thumb wheel on top of waterfall to the left (while in spa)
to start or increase ow.
B. Push thumb wheel on top of waterfall to the right (while in
spa) to slow or turn ow o.
NOTE: When the waterfall is in the OFF position, some water
may still ow through. This is considered normal.
CLEARRAY on Demand
The CLEARRAY on demand feature activates the water purica-
tion system for a period of 1-hour. Press the button to turn the
system on. During this time the circulation pump and the CLE-
ARRAY unit are on.
Note: When the CLEARRAY system is on, due to a programmed
or scheduled setting, the feature cannot be turned o.
Air Controls
Certain jet systems have their own “toggle” on/o air control.
Each control introduces air into the water lines that supply spe-
cic jet groups. Simply press any air control button Jacuzzi logo
side down to open or press the opposite side of button to close.
Note: To minimize heat loss, close all air controls (Jacuzzi logo
up) when spa is not in use. Certain jets may draw air even thou-
gh they are closed. This is considered normal.
Optional BLUEWAVE® Spa Stereo System
Spas equipped with the optional audio system oer enhanced
enjoyment. These models include a high-quality FM/USB/AUX/
Bluetooth stereo receiver with four high-quality marine spea-
kers for unsurpassed sound quality and long-life.
Note: Digital rights management (DRM) les cannot be played.
Personal les (MP3, WMA, iTunes or AAC) can be played as long as
they are not DRM encrypted les.
Blow-Out Cycle
This cycle will purge the air from the plumbing lines normally
caused by draining and lling the spa. The Jets Pump 1 and the
Circulation Pump will turn on for 1 minute and then shut o.
Then Jets Pump 2 will turn on and run for 1 minute then shut o.
This cycle will only occur at start up.
Note: Turning o the corresponding jets pump that is running can
deactivate the feature.
Cleanup Cycle
The cleanup cycle occurs once per day at 12:00 PM (noon) for 2
minutes. This is not user programmable. The Jets Pump 1 and the
Circulation Pump will turn on for one minute and then shut o.
Then Jets Pump 2 will turn on and run for 1 minute then shut o.
Note: Turning o the corresponding jets pump that is running can
deactivate the feature.
Menu Features and Programming Instructions
Your spa is equipped with menus that allow you to program addi-
tional features. By continually pressing the Menu ( ),button you
will cycle through the menus as follows:
Current temperature (Main Menu)
Primary Filtration
Secondary Filtration
Heat
Filter Change
UV
H2O
Time
Date
Temp
Language
To Next Page
Loading...
Need help?
General
