40
Combined, both lters provide unsurpassed water quality by
trapping surface oils and suspended particles. The lter cartridge
should be cleaned once a month or as necessary, depending on
use, for optimum performance.
TO DECREASE RISK OF DEATH, DROWNING OR ENTRAPMENT,
ALWAYS TURN POWER TO SPA OFF BEFORE CLEANING THE
FILTER CARTRIDGES!
Refer to steps on following page for complete lter cleaning/re-
placement instructions:
B
C
D
(Filter Cover Back View)
E
F
G
Trapped
Air
Bubbles
Cartridge 1
Cartridge 2
A. TURN POWER TO SPA OFF!
B. Lift upward on lter cover to remove it from the mating retain-
ing clips. Then tilt forward to access lter cartridges.
C. Remove skimmer bag from clips, then clean out debris.
D. Rotate each lter cartridge handle counterclockwise to un-
thread from mating wall tting.
E. Lift unthreaded lter cartridge from skimmer well.
F. Rinse debris from lter pleats on each cartridge using a garden
hose and high pressure nozzle. Start at the top and work down-
ward towards handle. Repeat until all pleats are clean.
G. Submerge both lter cartridges in spa. Tilt threaded end up-
ward to removed trapped air bubbles, then keep cartridges sub-
merged to prevent air entrapment during installation (step H).
H
I
J
(Filter Cover Back View)
H. Place each cartridge back into skimmer well, then rotated
each cartridge handle clockwise to thread back into wall tting.
DO NOT OVERTIGHTEN!
I. Install clean skimmer bag back onto the lter cover clips as
shown.
H. Place each cartridge back into skimmer well, then rotated
each cartridge handle clockwise to thread back into the wall t-
ting. Do not over tighten.
I. Install clean skimmer bag back onto the lter cover clips as
shown.
J. Tilt lter cover back then gently press down to latch against
retaining clips.
L. Turn power to spa back on.
Periodically, the lter cartridge will need a more thorough
cleaning to remove imbedded oils and minerals.
For this, we suggest cleaning followed by soaking the lter
overnight in a plastic container lled with a solution of water and
specially formulated lter cleanser available from your author-
ized Jacuzzi dealer.
The average life expectancy of each lter is approximately two
years with proper care and water quality maintenance.
The replacement cartridges can be purchased from your trusted
Jacuzzi® retailer.
Draining and Relling
About every 3 months, you will want to replace the spa’s water.
The frequency depends on a number of variables including the
amount of use, attention paid to water quality maintenance, etc.
You will know it is time for a change when you cannot control
sudsing and/or you can no longer get the normal feel or sparkle
to the water even though the key water balance measurements
are all within the proper parameters.
CAUTION! READ THIS BEFORE DRAINING: To prevent dam-
age to the spa’s components, turn o power to the spa at
the circuit breaker before draining it. Do not turn the power
back on until your spa has been relled.
To Next Page
Loading...
Need help?
General
