43
We recommend you consult your authorized Jacuzzi dealer for guid-
ance before attempting to restart your spa under these conditions.
Contact your Jacuzzi retailer if you have any questions about
using your hot tub in winter or preparing it for the winter.
Maintaining water quality
To reduce the risk of contracting water-related pathologies or res-
piratory diseases, the water quality must be kept within the specied
limits. This requires constant monitoring as the chemical aspect in-
volves a combination of dierent factors that need to be balanced.
Delaying water maintenance work leads to poor hygiene that is po-
tentially damaging to your health, and also has an impact on the
life of the hot tub.
For a specic guide to maintaining water quality, consult the Jacuz-
zi® system guide on water treatment and the relevant catalogue, or
contact your authorised Jacuzzi retailer.
CLEARRAY™ Water Purication System
The CLEARRAY water purication system is an exclusive technol-
ogy that takes advantage of natural ultraviolet radiation to elimi-
nate bacteria, viruses and algae potentially present in the hot tub
water. Ultraviolet light, also known as UV-C or germicidal light,
neutralises these organisms, also breaking down the DNA, so as
to prevent reproduction.
The CLEARRAY system, which is directly connected to your ltra-
tion system, works as follows:
- the water coming from the pump, from the lter and from the
heater is disinfected by ultraviolet light, after which it is intro-
duced back into the spa.
The system is equipped with a power converter whose operation
is signalled by two LEDs: the red one indicates that the device is
powered, while the green one indicates that it is operating cor-
rectly.
R
LB.
INDNESS
Power
on
Lamp
on
Note: the CLEARRAY system only works when the jets pump 1 is
operating at reduced speed (ltration, etc.).
After one year, the lamp must be replaced. If the UV timer has
been programmed correctly (please refer to the corresponding
section), at the end of the allotted time shown on the display, the
message “blb” will appear, indicating the need to install a new UV
lamp and to reset the timer.
UV lamp replacement and maintenance
of the quartz tube
To access the Clearray® device, it is necessary to remove the front
panel (or that of the audio system) and the right angle panel.
These operations should only be carried out by qualied in-
stallers. Please read the instructions carefully before carry-
ing out any operations involving the opening of the Clear-
ray® device.
WARNINGS
Do not look towards the UV lamp if it is turned on:
this can cause severe eye damage!
Do not power or turn on the Clearray® device during
maintenance operations
Improper use of the device can cause UV-C rays to
escape, which even in small amounts can damage
your skin and eyes.
Do not attempt to start damaged devices.
Disconnect the hot tub from the power supply.
Empty the hot tub if you intend to replace or clean
the quartz tube. Al-
low the UV lamp to cool down before removing the
quartz tube.
Proceed as follows:
Note: the layout and connection of the device may vary from model
to model.
1
2
3
4
7
5
8
9
11
12
10
6
1- After disconnecting the hot tub from the electrical network
and emptying it, wait for the UV lamp to cool down.
Note: the hot tub must be emptied in case of maintenance or re-
placement of the quartz tube.
It is not necessary to empty the tub when changing the UV lamp
2- Once the UV lamp has cooled down, remove the cover (2) to
access the lamp itself and its connections.
To Next Page
Loading...
Need help?
General
