23
J-300
10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting
pillows and plastic knobs from chemical attack. If
spa is indoors, open doors and windows for proper
ventilation. Turn on all jet pumps for one hour,
then place the massage selector knob in the
center “combo” position and open all air controls.
Note: You will need to press the jets pump button(s) every 20 minutes
since these functions have an automatic 20 minute time-out function that
turns them off.
WARNING: RISK OF PERSONAL INJURY!
• To decrease the risk of injury, drowning or entrapment,
never leave your hot tub unattended for any reason while
the cover is open and accessible, especially to small chil-
dren and animals!
• Precautions should be taken to minimize your exposure
to chemical vapors (that could cause lung, brain, or skin
damage).
!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in “Draining and Relling” (page 42).
12. Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. DO NOT OVERFILL.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never ll with water from a water softener. If your water is extremely
“hard,” it is preferable to ll half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive to
metal components.
13. Consult your authorized Jacuzzi dealer for chemical recommenda-
tions, then add chemicals to hot tub water to achieve a constant
sanitizer reading within the levels recommended on the inside cover
of this manual.
14. Turn on all jets pump(s) when adding chemicals to ensure proper
mixing and leave your hot tub cover open until the sanitizer level
becomes stable to protect pillows and plastic knobs from chemical
attack. Refer to the inside cover of the manual.
To Next Page
Loading...
Need help?
General
