22
J-300
8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER: RISK OF PERSONAL INJURY.
Check water temperature carefully before entering hot tub!
Excessive water temperature can cause burns, welts and body
temperature to rise, hyperthermia (over-heating).
!
Decontamination Procedure (Steps 9-16)
Steps 9-16 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable after performing steps 1-6 above (refer to the inside
cover of the manual).
9. Add 2.5 ounces (71 g) of sodium dichlor for every 100 gallons (378
Liters) of water. Refer to the table below for approximate water ll
volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your hot tub for
any reason! These chemicals may damage components within
your hot tub, burn or irritate your skin, create a rash, and void
the manufacturer warranty for your spa.
!
Water Fill Volume by Model
Spa Model Average Fill Volume* Sodium Dichlor
J-385 500 Gal (1,893 L) 12.5 oz
J-375 470 Gal (1,779 L) 11.75 oz
J-365 440 Gal (1,666 L) 11.0 oz
J-355 400 Gal (1,514 L) 10.0 oz
J-345 370 Gal (1,401 L) 9.25 oz
J-335 360 Gal (1,363 L) 9.0 oz
J-325 360 Gal (1,363 L) 9.0 oz
J-315 230 Gal (871 L) 5.75 oz
*Use average ll volume for chemical maintenance
To Next Page
Loading...
Need help?
General
