Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a
list of automated functions performed by your spa. These functions are listed
below in an attempt to suppress any operational concerns you may have during
recommendations you should observe on a regular basis to protect your new
investment.
Automated Spa Operations
Your new spa is equipped with an automated “blow-out” cycle that clears all
plumbing lines daily to promote maximum water sanitation. Each day at 12:00
PM (noon), pump 2 will automatically turn on for a period of one minute, then go
off. Then pump 1 will turn on and run for one minute to complete the blow-out
cycle. Be aware, the factory programmed blow-out cycle cannot be canceled or
altered!
Maintain Healthy Spa Water
pH 7.4-7.6
Free Chlorine 3.0-4.0 ppm
Free Bromine 2.0-4.0 ppm
100-120 ppm
Calcium Hardness 150-250 ppm
Refer to page 46-47 for additional information.
Required Filter Maintenance
unsurpassed water quality! To ensure maximum water quality at all times, you
Required Water Replacement
a number of variables including frequency of use, number of users and attention
proper parameters. See page 46-47 for additional information.
To Next Page
Loading...
