Page 39
4. Press DISPLAY button to save changes and recall the main
water temperature display. Note: If no button is pressed within 30
seconds, all changes are recorded and the screen automatically
returns to the standard water temperature display.
displays the following message:
1*
CYCLE button then moving through
the menu by pressing either CYCLE or SELECT button. The
programming is changed only by pressing WARMER or COOLER
buttons during this process.
11.3 Adjusting Time of Day
The Sentry control system remembers the time of day even in the event
of a prolonged power outage. However, it may occasionally be neces-
Time Zone you will want to reset the time for your own time zone. (The
accomplish this, press DISPLAY , MODE and DISPLAY
each time WARMER or COOLER
seconds. Then, press DISPLAY button again to display the min-
WARMER or
COOLER
and save your settings.
11.4 Main Control Panel Lock
To help prevent unauthorized use of your spa, the Sentry controls incor-
panel.
*Note: Number will
vary according to which
programmed.
To Next Page
Loading...
