Page 38
running, but no apparent change of operation will occur. However, when
“Economy” mode is selected (sec. 10.3, page 36), the heater activates
only during a programmed lter cycle.
When in a Summer Logic condition is active (see note below), the lter/
circulation pump will turn on for all programmed lter cycles.
Summer Logic: In warm weather, the water temperature in the spa
may exceed the set temperature. This condition may occur due to
If the water temperature is higher than 95°F (35°C) and rises two
degrees above the set temperature, a “Summer Logic” condition occurs
equipped). This safety feature cannot be altered!
pump and ozonator will remain off until the water temperature cools to
-
-
tion pump cycles run times in warm weather.
CYCLE
cycle programming mode. The LCD screen will display the following in
the upper right corner:
1*
This means the system is ready to accept your changes to the start time
for cycle number one. Simultaneously, the large four-digit display in the
center of the screen displays the currently programmed start time for that
1. Press WARMER or COOLER
time in increments of 30 minutes.
2. Press CYCLE
cycles start time. With each press, the currently programmed status
value, simply press the WARMER or COOLER button.
3. Press SELECT button to move down the menu from Start Time to
Duration, with each press, the currently programmed duration will be
shown in the large four-digit display. Press WARMER or COOLER
*Note: Number will
vary according to which
programmed.
To Next Page
Loading...
