Page 52
IMPORTANT: If freezing conditions exist and pump is not operational,
titled “Winterizing” (page 45).
(see page 28-35)
41-43).
1. Reduce thermostat setting (page 15).
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed filter
cycles (page 36).
2. Keep the cover in place while heating.
3. If “heater on” indicator is lit (page 19), but
no temperature rise is experienced after
a reasonable period of time, contact your
dealer or authorized service center.
-
grammed to run 24-hours a day (page
37).
power interruption. Wait 24-hours for hot
tub to reset.
3. Hot tub water is warmer than 95°F (35°C)
and two degrees warmer than the set
temperature. The “Summer Logic” safety
feature has activated. See note on page
38 for details.
To Next Page
Loading...
