111
Insufficient water level
• The water in the tub is below the required level and the pump
is stopped.
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
You will need to add the required amount of water and re-
peat the steps described in the chapter on sanitizing. Make sure
you turn the remote control off and then back on.
Insufficient disinfectant liquid level
• The cycle does not start and the LED for the key on the
recharger flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
You will need to add the required amount of disinfectant liq-
uid within one minute and repeat the steps described in the chap-
ter on sanitizing. If the water level is not restored within 1
minute, the cycle is cancelled.
To return to normal remote control display, press any key.
THE DISINFECTION CYCLE STOPS BY ITSELF
First of all, check that the main switch on the power supply
line of the tub is on and that there is not a power outage. Also
make sure you have complied with the instruction provided in
the relative chapter.
If there are any other irregularities, please refer to the following
instructions.
Defects concerning the electronics box
Refer to the paragraph entitled "Hydromassage does not start".
Electronic safety cut-out protection in operation.
Refer to the paragraph entitled "Hydromassage does not start".
Decrease of level of water in tub.
This condition may occur in the last minute of the cycle due to
accidental opening of the drain.
The manner in which the anomaly is displayed is the same as in
the paragraph "insufficient water level".
Proceed as follows to restore tub operation:
You will need to add the required amount of water within five
minutes from the appearance of the alarm. The cycle will pick up
where it left off and continue until the end. If the level is not re-
stored within five minutes, the cycle will be permanently inter-
rupted with no further warning, since it can be considered
complete.
To return to normal remote control display, press any key.
No disinfectant liquid left
The manner in which the anomaly is displayed is the same as
in the paragraph "insufficient disinfectant liquid level".
Proceed as follows to restore tub operation:
You will need to add the required amount of liquid within five
minutes from the appearance of the alarm. The cycle will pick up
where it left off and continue until the end. If the level is not re-
stored within five minutes, the cycle is permanently interrupted
and the LED stays on for about sixty minutes, to show that the
cycle was not completed.
To return to normal remote control display, press any key.
To Next Page
Loading...
Need help?
General
