ENGLISH
23
Jacuzzi Whirlpool Bath EL21000B 10/06
Lamp
All units come standard with an underwater LED light
fi xture. There are no internal replacement parts for the LED
light fi xture.
Replacement fi xtures are available from your Jacuzzi
Whirlpool Bath dealer.
Repairs to the Surface
Minor scratches which do not penetrate the color fi nish can
be removed by lightly sanding with 600-grit wet/dry sandpaper.
Restore the gloss using Meguiar's Mirror Glaze a product
specifi cally designed for use on acrylic fi nishes. If Meguiar's
is not available, an acrylic polish of equal quality or automotive
paste wax is acceptable.
Never use abrasive household cleaners on any Jacuzzi
Whirlpool Bath product.
Major scratches and gouges which penetrate the acrylic
surface will require refi nishing. To obtain a referral for a service
agent in your area call 1-800-288-4002 or visit our web site at
http://www.jacuzzi.com/.
Suction Cover/Strainer Maintenance
Clean the suction cover/strainer of hair and debris when
necessary. To do this, remove the center screw and detach
the square cover. Clean the cover by backfl ushing debris
from the holes. Replace the suction cover immediately after
cleaning. When reinstalling, orient the cover/strainer with the
small notch at the bottom. The gasket must be inserted into
the groove of the cover/strainer before reinstalling onto the
suction fi tting.
CAUTION: Keep hair a minimum of 6 inches (15,2 cm) away
from the suction fi tting at all times when the whirlpool sys-
tem is operating. Hair longer than shoulder length should
be secured close to the head, or a bathing cap should
be worn.
Do not operate the whirlpool system
with the suction cover/strainer removed! It is a
safety device and must always be in place on the suction
fi tting to minimize the potential hazard of hair and body
entrapment.
NOTCH
GASKET
COVER STRAINER
SCREW
SUCTION
FITTING
SUCTION COVER/STRAINER ASSEMBLY
LIGHT BEZEL
SHELL
LOCKING NUT
LED LIGHT ASSEMBLY
MAINTENANCE INSTRUCTIONS
To Next Page
Loading...
Need help?
General