(II)
17
2012.02.20 13:14:15
10
pcs
2012.02.20 13:14:15
0.500 kg
2012.02.20 13:14:15
N.W.: 0.500 kg
U.W.: 0.0500 kg/pcs
Total: 10pcs
2012.02.20
13:14:15
10
pcs
2012.02.20
13:14:15
0.500 kg
ERR4
EEPROM Chksum failure
Re-weld EEPROM or contact the
maintenance department.
ERR5
Overload condition Remove the overload item
ERR6
Exceeds the display range -----------------------------------------------
ERR8 Lower limit is higher than upper limit
Reset the weight limit value.
ERR9
Exceed tare or pre-tare range
0＜Tare value≤ full load
ERR10
Wrong calibration weights
Place the right test weights and the
calibration value should be below full load.
Appendix 1
BIRCH/GODEX/ZEBRA printing format
Prt-01 Prt-02
Prt-03
CK、DMP
printing format
Prt-01 Prt-02
To Next Page
Loading...
Need help?
General
