What to do if Jadever JWL-3K Scales show wrong calibration weights?
If your Jadever Scales display an error related to calibration weights, ensure that you are using the correct weights, matching the calibration value to the full load.
What to do if Jadever JWL-3K Scales show overload condition?
If your Jadever Scales indicate an overload condition, remove the weight from the pan that exceeds the scale's capacity.
What to do if Jadever JWL-3K exceed tare or pre-tare range?
If Jadever Scales exceed the tare or pre-tare range, ensure that the tare value is above zero and does not exceed the full load capacity.
What to do if Jadever Scales exceed the initial zero point?
If your Jadever Scales exceed the initial zero point: 1. Check the scale pan for any foreign objects and remove them. 2. If the issue persists, it may indicate a load cell failure, requiring replacement or professional service.
How to fix EEPROM failure in Jadever JWL-3K?
If you encounter an EEPROM failure with your Jadever Scales, re-solder the EEPROM.
What to do if the accumulated number of weighments exceeds the display range on Jadever JWL-3K Scales?
If the accumulated number of weighments exceeds the display range on your Jadever Scales, delete the excess weighments.
What to do if Jadever JWL-3K lower limit is higher than upper limit?
If the lower limit is higher than the upper limit on your Jadever Scales, re-enter the upper limit and lower limit settings.
What to do if Jadever JWL-3K exceed the A/D resolution range?
If your Jadever Scales exceed the A/D resolution range: 1. Check for A/D failure and replace the A/D if necessary. 2. If the problem persists, it may indicate a load cell failure, requiring replacement or professional service.
What to do if Jadever Accessories shows overload condition?
If your Jadever Accessories display shows an overload condition, it means the weight on the scale pan is exceeding its capacity. Remove the excess weight from the pan to resolve this issue.
Why does my Jadever Accessories exceed the initial zero point?
If your Jadever Accessories exceeds the initial zero point, first check the scale pan for any foreign objects and remove them. If the problem persists, it may indicate a LOAD CELL failure, which requires replacement or professional service.
Check instrument for transport damage and missing parts upon receipt.
Instructions for installing components, including removing protection screws.
Details on scale models, capacity, division, pan size, and general features.
Detailed description of each key's function and operation.
Step-by-step guide to entering and navigating function settings.
Guide to setting lower and upper limits for check weighing.
Steps for performing simple counting using sample quantities.
Table of error messages, their problems, and troubleshooting steps.
To Next Page
General
