Why doesn't the buzzer work on my Jadever JCL-30K Scales?
If the buzzer on your Jadever Scales isn't working, Q11 or Q8 may be defective; check and replace them if necessary. Alternatively, the buzzer itself may be defective, or there could be a fault in the buzzer circuit, requiring replacement.
How to troubleshoot keypad dysfunction on Jadever JCL-30K Scales?
If the keypad on your Jadever Scales is not functioning correctly, the keypad or keypad circuit might be faulty; check and replace them if needed. Another possible cause is a CPU or CPU program issue; in this case, check and replace the CPU. Additionally, component 74LS139 could be defective; check and replace it if necessary.
What causes memory dysfunction in Jadever JCL-30K Scales?
If your Jadever Scales are experiencing memory dysfunction, the component 24C02, R29, R30, R31, or CP18 may be defective. Check these components and replace any that are faulty.
Why do I get messy code in printouts from my Jadever JCL-30K?
If you are getting messy code in the printouts from your Jadever Scales, it could be due to a wrong setting. Check and reset the external device, baud rate, and print mode. The RS-232 board could also be defective, so check and replace it if necessary. A bad connection between the RS-232 board and the main board could also be the problem; check and replace the wire connection. Finally, the external device itself may be defective and require maintenance or replacement.
What to do if the LCD backlight on my Jadever Scales has no function?
If the LCD backlight on your Jadever Scales is not functioning, the LCD backlight itself may be defective and require replacement. Alternatively, a component may be defective; check and replace Q9, CPU, P71, R72, R73, R74, R75, and R76.
What does the battery symbol mean on my Jadever JCL-30K?
If a battery symbol appears on your Jadever Scales, it could indicate insufficient cell voltage. Try recharging the battery. If the voltage of the battery is lower than 5.7V and the battery indication lamp is still green, replace the rechargeable battery immediately. A defective component could also be the cause; check and replace R34, R35, R36, and Q10. Finally, a bad connection between R34 and LM2930 could be the issue; repair the wire connection between these components.
Guide for calibrating the scale using single or multiple points.
How to perform tare and preset tare operations.
Setting high and low limits for weight checking.
Setting high and low limits for quantity checking.
How to input unit weights and perform basic counting.
Performing sample counting and Automatic Counting Accuracy Improvement (ACAI).
How to accumulate, display, and clear data.
Common error messages and their solutions.
To Next Page
General
