Page 6 WEIGHING SCALE
VIII. WEIGHING UNIT CONVERSION
1 kg = 1000 g
1 斤 = 500g
1 HK jin = 16 HK ounce 1 HK ounce = 37.799375g
1 Taiwan ounce = 37.49995g 1 Taiwan jin = 16 Taiwan ounce
1 lb = 453.59237g 1 oz = 28.3495231g
IX. FACTORY SETTING
A. LINEAR CALIBRATION
1. Power on while holding down TARE key, the display will show Line .
2. Press MODE key to enter into automatic factory calibration mode, the display will show On0 ,
put weight of 1/3 full load on the weighing pan when On1 appears, press TARE key until
On2 appears, put weight of 2/3 full load on the weighing pan, press TARE again, On3 will
appear on the display, press TARE after putting weight of full load on the weighing pan and wait
until PASS appears.
3. Take off the weight, press ZERO key to return to weighing mode.
B. SINGLE-POINT CALIBRATION
1. Power on while holding down MODE key to enter into setting mode, the display shows CAL .
2. Press TARE key to enter into single-point calibration mode, the display will show On0 , wait
until CAP appears.
3. Press MODE key to select calibration weight, the display will show in turn CAP 1 , CAP2 ,
and CAP3 ; put corresponding weights of 1/3, 2/3 or full load on the weighing pan, then press
TARE key to enter into single-point calibration mode, wait until the display shows PASS .
4. Take off the weights, press ZERO key to return to weighing mode.
C. PRECISION SETTING- (Only applicable for version 2.0 and above)
1. Power on while holding down PRINT key to enter into setting mode, the display will show
SEnC .
2. Press TARE key to select SEnC1 or SEnC2 .
3. SEnC1 means precision 15000, SenC2 means precision 6000 (7500).
4. After setting is completed, press ZERO key to return to weighing mode.
APPENDIX 1:
ERROR MESSAGE
1. Error message
Err. Msg. Problem
Err2
Initial zero point over ±10% (take 10% as the benchmark)
Err3 Over or below A/D resolution range FFFFF
Err4 EEPROM Chksum error
Err5 Overload (max. capacity +9e)
Err6
Wrong calibration weight
Battery
symbol
Low battery
To Next Page
Loading...
Need help?
General
