Jandy LG325 User Manual

WARNING: FOR YOUR SAFETY -
This product must be installed and serviced by
a professional service technician, qualified in pool heater installation. Improper instal-
lation and/or operation could create carbon monoxide gas in flue gases which could
cause serious injury, property damage, or death. For indoor installations, as an addi-
tional measure of safety, Waterpik Technologies strongly recommends installation of
suitable Carbon Monoxide detectors in the vicinity of this appliance and in any adja-
cent occupied spaces. Improper installation and/or operation will void the warranty.
H0264600A
Installation and Operation Data
WARNING: If these instructions are not followed exactly, a fire or explosion may
result, causing property damage, personal injury, or death.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a nearby phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency,
or the gas supplier.
Installation and
Operation Manual
Lite2
™
Pool and Spa Heater
Model LG
Natural Gas or LP Gas

Jandy LG325 Specifications

General

Model	LG325
Category	Swimming Pool Heater
Type	Gas Pool Heater
Heating Capacity	325, 000 BTU/hr
Water Flow Rate	40-120 GPM
Minimum Water Flow	40 GPM
Maximum Working Pressure	50 PSI
Ignition	Electronic
Fuel Type	Natural Gas
Warranty	2 years

Summary

Product Overview and Installation Preparation

Introduction and Safety Warnings

Manual's purpose, heater model, and critical safety precautions for installation and use.

Specifications and Materials

Details heater dimensions, capacities, and required materials for installation.

Codes, Standards, and Technical Assistance

Outlines applicable codes, standards, and how to get technical support.

Installation and Venting Procedures

Site Selection and Clearances

Guidelines for choosing a location, required clearances, and flooring requirements.

Venting and Combustion Air

Details combustion air supply and vent pipe sizing for safe exhaust.

Connections, Operation, and Maintenance

Gas and Water Connections

Instructions for gas supply, water piping, and connections.

Electrical System and Operation

Covers electrical setup, normal operation, and starting procedures.

Maintenance and Seasonal Care

Procedures for water chemistry, routine inspections, and seasonal adjustments.

Troubleshooting, Parts, and Warranty

Troubleshooting and Diagnostics

Identifies common problems, causes, remedies, and diagnostic procedures.

Replacement Parts and Diagrams

Lists available parts and provides exploded views for identification and ordering.

Limited Warranty Information

Outlines the terms, conditions, and claim process for the product warranty.