Need help?Do you have a question about the Jandy PRO Series JXI400 and is the answer not in the manual?
General| Model | JXI400 |
|---|---|
| Category | Swimming Pool Heater |
| Maximum Flow Rate | 120 GPM |
| BTU Input | 400, 000 BTU |
| Fuel Type | Natural Gas |
| Voltage | 120V |
| Inlet/Outlet Size | 2" |
Crucial safety warnings, gas leak procedures, and installation requirements.
Recommended chemical levels for pools and spas for optimal performance and longevity.
Locating the model and serial number on the heater's rating plate.
Required minimum clearances for safe operation and access around the unit.
Specific clearance requirements for combustible surfaces and service access.
Clearances for outdoor installations, indoor venting, and side wall termination.
Guidelines for gas line sizing, pressure testing, and sediment trap installation.
Instructions for electrical connections, voltage selection, and wiring diagrams.
Instructions for securely fastening the heater using anchor brackets.
Step-by-step description of the heater's start-up and operation cycle.
Explanation of buttons and their functions on the heater control panel.
Guide to setting display language, temperature units, and backlight.
How to turn on, maintain heat, and lock/unlock temperature set points.
Instructions for remote wiring connections and 2-wire remote setup.
List of control panel messages and their corresponding faults for troubleshooting.
Description of key safety controls like limit switches and sensors.
Step-by-step guide for replacing the thermal regulator valve.
Contact information for technical support in the US and Canada.
To Next Page
