Jandy Hi-E2 EHe User Manual

FOR YOUR SAFETY - This product must be installed and serviced by authorized person-
nel, qualified in pool/spa heater installation. Improper installation and/or operation can
create carbon monoxide gas and flue gases which can cause serious injury, property
damage, or death. For indoor installations, as an additional measure of safety, Jandy Pool
Products, Inc. strongly recommends installation of suitable Carbon Monoxide detectors in
the vicinity of this appliance and in any adjacent occupied spaces. Improper installation
and/or operation will void the warranty.
H0205000D
Installation and Operating Data
WARNING
If these instructions are not followed exactly, a fire or explosion may result,
causing property damage, personal injury, or death.
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service
agency or the gas supplier.
Installation and
Operation Manual
Hi-E2
™
Model EHE
Gas-Fired Pool
and Spa Heater

Jandy Hi-E2 EHe Specifications

General

Model	Hi-E2 EHe
Category	Swimming Pool Heater
Heating Capacity	Up to 400, 000 BTU/hr
BTU/hr Input	400, 000 BTU/hr
Energy Efficiency	Up to 95%
Efficiency	Up to 95% Thermal Efficiency
Fuel Type	Natural Gas or Propane
Control System	Digital
Dimensions	Varies by model
Weight	Varies by model
Water Flow Rate	40-120 GPM
Ignition	Electronic
Warranty	2 years

Summary

General Information and Warranty

Introduction and Product Description

Overview of manual content and heater features, efficiency, and certifications.

Warranty Information

Details limited factory warranty, exclusions, and claims process.

Installation Instructions

General Requirements and Location

Essential requirements, site selection, clearances, and outdoor installation.

Combustion Air and Venting Systems

One-pipe/two-pipe requirements, air pipe connection, and pipe sizing.

Condensate Disposal and Gas Piping

Handling condensate and requirements for gas supply and piping.

Electrical and Water Connections

Electric wiring, bonding, remote controls, and water piping.

Heater Start-up and Adjustments

Initial startup, temperature controls, and pressure switch adjustment.

Operating Instructions

Temperature Controls and Basic Operation

Using temperature controls and understanding normal operation.

Lighting and Shutdown Procedures

Step-by-step instructions for lighting and shutting down the heater.

Water Chemistry and Safety

Maintaining proper water balance for pools and spas, and safety rules.

Seasonal Care and Energy Savings

Tips for energy conservation and seasonal maintenance.

Periodic Inspections

Owner inspection guidelines for maintaining heater condition.

Maintenance and Service

General Service and Component Overview

Service safety, technician requirements, and component functions.

Electrical Troubleshooting

Checking power supply and control circuit issues.

Venturi Combustion Flow System

Checking air flow, gas orifice, and pressure measurements.

High Elevation Operation

How the venturi system compensates for elevation.

Specifications and Parts

Capacities, Dimensions, and General Specs

CSA certification, fuel types, power, and pressure.

Replacement Parts List

List of available parts with model and order numbers.