EasyManua.ls Logo

Jandy Hi-E2 EHe - Limited Warranty

Jandy Hi-E2 EHe
36 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 34
JANDY POOL PRODUCTS , INC
6000 Condor Drive, Moorpark, CA, USA 93021 707.776.8200 FAX 707.763.7785
Litho in U.S.A. © Jandy Pool Products, Inc. 0507
Jandy
®
, Lite
®
, LX
®
and HI-E2
®
are registered trademarks of Jandy Pool Products, Inc.
All other brand names, products names or trademarks belong to their respective holders.
H0205000D
LIMITED WARRANTY
Thank you for purchasing Jandy® pool and spa products. Jandy Pool Products, Inc. warrants all parts to be
free from manufacturing defects in materials and workmanship for a period of one year from the date of retail
purchase, with the following exceptions:
AquaLink® RS units installed with Jandy Surge Protection Kits will be covered for two years.
• NeverLube® valves are warranted for the life of pool and/or spa on which they were originally installed.
This warranty is limited to the fi rst retail purchaser, is not transferable, and does not apply to products that
have been moved from their original installation sites. The liability of Jandy Pool Products Inc. shall not
exceed the repair or replacement of defective parts and does not include any costs for labor to remove and
reinstall the defective part, transportation to or from the factory, and any other materials required to make the
repair. This warranty does not cover failures or malfunctions resulting from the following:
1. Failure to properly install, operate or maintain the product(s) in accordance with our published Installation,
Operation and Maintenance Manuals provided with the product(s).
2. The workmanship of any installer of the product(s).
3. Not maintaining a proper chemical balance in your pool and/or spa [pH level between 7.2 and 7.8, Total
Alkalinity (TA) between 80 to 120 ppm, Total Dissolved Solids (TDS) less than 2000].
4. Abuse, alteration, accident, fi re, fl ood, lightning, rodents, insects, negligence or acts of God.
5. Scaling, freezing, or other conditions causing inadequate water circulation.
6. Operating the product(s) at water fl ow rates outside the published minimum and maximum specifi cations.
7. Use of non-factory authorized parts or accessories in conjunction with the product(s).
8. Chemical contamination of combustion air or improper use of sanitizing chemicals, such as introducing
sanitizing chemicals upstream of the heater and cleaner hose or through the skimmer.
9. Overheating, incorrect wire runs; improper electrical supply; collateral damage caused by failure of
ORings, DE grids, or cartridge elements; or damage caused by running the pump with insuffi cient quanti-
ties of water.
LIMITATION OF LIABILITY:
This is the only warranty given by Jandy Pool Products, Inc. No one is authorized to make any other war-
ranties on Jandy Pool Products, Inc.'s behalf. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRAN-
TIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF
FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY. JANDY POOL PRODUCTS, INC.
EXPRESSLY DISCLAIMS AND EXCLUDES ANY LIABILITY FOR CONSEQUENTIAL, INCIDENTAL, IN-
DIRECT OR PUNITIVE DAMAGES FOR BREACH OF ANY EXPRESSED OR IMPLIED WARRANTY. This
warranty gives you specifi c legal rights. You may also have other rights which vary by state or province.
WARRANTY CLAIMS:
For prompt warranty consideration, contact your dealer and provide the following information: proof of
purchase, model number, serial number and date of installation. The installer will contact the factory for
instructions regarding the claim and to determine the location of the nearest designated service center. If the
dealer is not available, you can locate a service center in your area by visiting www.jandy.com or by calling
our technical support department at (707) 776-8200 extension 260. All returned parts must have a Returned
Material Authorization number to be evaluated under the terms of this warranty.

Table of Contents

Related product manuals