EasyManua.ls Logo

Jandy 200 User Manual

Jandy 200
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
H0404700 Rev D
WARNING
If these instructions are not followed exactly, a fire or explosion may
result, causing property damage, personal injury, or death.
FOR YOUR SAFETY: This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in
which the product will be installed where such state or local requirements exists. In the event no such state or local requirement exists, the installer or
maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in this manual
can be followed exactly. Before installing this product, read and follow all warning notices and instructions that accompany this product. Failure to follow
warning notices and instructions may result in property damage, personal injury, or death. Improper installation and/or operation can create carbon
monoxide gas and flue gases which can cause serious injury, property damage, or death. For indoor installations, as an additional measure of safety,
Zodiac Pool Systems, Inc. strongly recommends installation of suitable carbon monoxide detectors in the vicinity of this appliance and in any adjacent
occupied spaces. Improper installation and/or operation will void the warranty.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Immediately switch off main gas supply.
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
INSTALLATION AND
OPERATION MANUAL
Jandy Pro Series
JXi
Gas-Fired Pool and Spa Heater
Models 200, 260, 330, 400

Table of Contents

Questions and Answers:

Jandy 200 Specifications

General IconGeneral
BrandJandy
Model200
CategorySwimming Pool Heater
LanguageEnglish

Summary

General Information

Introduction

Provides an overview of the installation and operation manual for the Jandy Pro Series JXi pool and spa gas heater.

Technical Assistance

Contact information for technical support and questions regarding the Jandy Pro Series JXi heater.

Consumer Safety Guidelines

Important safety rules for hot tubs and energy saving tips for swimming pools.

Installation Requirements

Introduction and Materials

Overview of installation requirements and list of materials the installer must provide.

Specifications

Details technical specifications including location, clearances, and connections for the JXi heater.

Heater Components

Describes the key components of the JXi heater, such as the gas valve and igniter.

Dimensions and Clearances

Provides exterior dimensions and required clearances for safe installation and operation.

Service Access and Location

Details access requirements for servicing and general location requirements for the heater.

Indoor Installation Guidelines

Specific requirements and warnings for installing the heater indoors.

Venting Requirements

Combustion Air Supply

Ensures proper ventilation and air supply for safe combustion.

Exhaust Venting and Sizing

Guidelines for sizing, installing, and routing exhaust vent pipes.

Vertical Venting (Category I)

Instructions for installing vertical venting systems for Category I appliances.

Category III Venting

Guidelines for vertical or horizontal venting as a Category III appliance.

Gas Connections

Piping and Gas Supply

Instructions for installing gas piping and checking the gas supply pressure.

LP Gas Precautions

Specific safety precautions and installation restrictions for liquid propane (LP) gas.

Water Connections

Piping and Pump Sizing

Details on water piping connections and recommended pump flow rates.

Plumbing and Inlet Piping

Describes plumbing connections and optional water inlet piping configurations.

Water Pressure Switch Adjustment

Procedure for adjusting the water pressure switch for proper operation.

Valve Installation and Connections

Instructions for installing check valves and pressure relief valves.

Auxiliary Components and Chemicals

Guidance on compatibility with auxiliary components like chlorinators and ozone generators.

Electrical Connections

General Electrical Information

Overview of electrical wiring requirements and grounding.

Service Access and Main Power

How to access electrical components and connect main power.

120V Power Conversion

Instructions for converting the heater to a 120V power source.

Bonding and Remote Controls

Requirements for bonding electrical components and connecting optional remote controls.

"Smart" Communication via RS-485

Details on establishing RS-485 communication with control systems.

Operating Instructions

First-Time Start-Up Procedure

Step-by-step guide for the initial start-up of the heater.

Starting the Heater

Detailed instructions for safely starting the heater and lighting the burners.

Heater Setup Options

Configuration of language, temperature scale, and display light timeout.

Operating the Heater

Instructions for operating the heater for pool and spa modes.

Shutting Down the Heater

Procedure for safely shutting down the heater.

Maintenance

Winterizing and Spring Start-up

Procedures for winterizing the heater and preparing it for spring start-up.

Inspection and Service

Guidelines for regular inspection and professional servicing of the heater.

Troubleshooting

Common Problems and Solutions

A table outlining common issues, their possible causes, and remedies.

Service Diagnostic Messages

Explanation of fault messages displayed by the controller and their solutions.

Professional Service

Gas Pressure Offset Test

Procedure for performing a gas pressure offset test on the heater.

Spare Parts

Ordering Information and Major Components

Guide to ordering replacement parts and overview of major heater components.

Cabinet Assembly Parts

List and exploded diagram for cabinet assembly spare parts.

Heat System Parts

List and exploded diagram for combustion chamber assembly spare parts.

Burner Assembly Parts

List and exploded diagram for burner assembly spare parts.

Water System Parts

List and exploded diagram for manifold assembly spare parts.

Electrical System Parts

List and exploded diagram for electrical system spare parts.

Water Chemistry

Related product manuals