Jandy PLC1400 User Manual

Jandy
AquaPure
®
Electronic
Salt Water Chlorinator
And
INSTALLATION AND
OPERATION MANUAL
PureLink™
Water Purication System
Power Center and Cell Kit
Models:
APUREM
PLC700
PLC1400
H0325600 Rev F
ENGLISH
WARNING
If these instructions are not followed exactly, a fire or explosion may
result, causing property damage, personal injury, or death.
FOR YOUR SAFETY: This product must be installed and serviced by a contractor who is licensed and qualified
in pool equipment by the jurisdiction in which the product will be installed where such state or local requirements
exists. In the event no such state or local requirement exists, the installer or maintainer must be a professional with
sufficient experience in pool equipment installation and maintenance so that all of the instructions in this manual
can be followed exactly. Before installing this product, read and follow all warning notices and instructions that
accompany this product. Failure to follow warning notices and instructions may result in property damage, personal
injury, or death. Improper installation and/or operation will void the warranty.

Jandy PLC1400 Specifications

General

Brand	Jandy
Model	PLC1400
Category	Water Filtration Systems
Language	English

Summary

Important Safety Instructions

To Reduce the Risk of Injury

Detailed safety precautions for spa and hot tub use, covering water temperature and user health.

Installation Instructions

Materials and Tools for Installation

Plumbing Configurations and Sensor Orientation

Details on recommended cell and sensor orientation and plumbing layouts.

Control/Power Center Installation

Step-by-step guide for mounting the control and power centers.

Electrolytic Cell and Sensor Installation

Detailed steps for installing the cell and sensor assembly.

Connection to AquaLink Control System

Pool Water Preparation

Optimum Pool Water Conditions

Salt Level Management

Details on salt type, quantity, and addition for the chlorinator.

Operating Instructions

User Interface Controls

System Startup Procedures

Applying Power and Initial Calibration

Detailed steps for powering on, self-calibration, and setting salinity/chlorine.

User Maintenance Instructions

Electrolytic Cell Cleaning

Instructions for automatic and acid wash cleaning of the electrolytic cell.

Winterizing the System

Troubleshooting

Troubleshooting Common Problems

Identifies common issues and provides solutions.

Understanding Service Codes

Lists error codes and their possible causes and corrective actions.

Interpreting Letter Codes