EasyManua.ls Logo

Jandy Versa-Plumb CL 460 - User Manual

Jandy Versa-Plumb CL 460
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
H0291800C
Installation and
Operation Manual
Jandy
®
Cartridge
Pool Filters
CL and CV Versa-Plumb
™
Series Filters
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a professional pool/
spa service technician. The procedures in this manual must be followed exactly. Improper
LQVWDOODWLRQDQGRURSHUDWLRQFDQFUHDWHGDQJHURXVKLJKSUHVVXUHZKLFKFDQFDXVHWKH¿OWHU
lid to be blown off, possibly causing death, serious injury or property damage. Improper
installation and/or operation will void the warranty.
Before installing this product, read and follow all warning notices and instructions that
DFFRPSDQ\WKLV¿OWHU)DLOXUHWRIROORZZDUQLQJQRWLFHVDQGLQVWUXFWLRQVPD\UHVXOWLQ
property damage, serious injury, or death.
b
™
Installation and Operation Data

Table of Contents

Questions and Answers

  • R
    rscottAug 8, 2025
    How to fix low water flow in Jandy Water Filtration Systems?
    • S
      Sarah BryantAug 8, 2025
      Low water flow in your Jandy Water Filtration System can be caused by several issues. Start by checking and cleaning the filter system strainer baskets. Inspect all connections between the pool intake and pump for air leaks. Look for restrictions or blockages in the suction or return lines, ensuring all lines are free of debris and valves are fully open. Clean or replace the filter cartridges as per the instructions. Ensure the pool water level is above the pump inlet line. Prime the pump by filling it with water at the basket and replacing the lid. Note that blocked pump impeller vanes or the pump operating under speed (low voltage) require a technician or electrician.
  • L
    Linda TorresAug 14, 2025
    Why is my Jandy Water Filtration System water not clear?
    • N
      Nicole WelchAug 14, 2025
      Unclear water in your Jandy Water Filtration System can stem from several factors. It could be due to an insufficient disinfectant level, which requires checking and adjustment. Incorrect pool chemistry also plays a role and needs testing and adjustment. Heavy usage or dirt loads might necessitate adjusting the filter time or water chemistry. Insufficient running times require increasing the pump run time. A dirty filter needs cleaning as per the instructions, and a hole in the filter element means the cartridge must be replaced.
  • A
    Alice HarrisAug 19, 2025
    What to do if Jandy Versa-Plumb CL 460 have short filter cycles?
    • W
      William DavilaAug 19, 2025
      Short filter cycles in your Jandy Water Filtration System can arise from a few reasons. Algae clogging the filter may be the cause, so check the disinfectant content. Incorrect water chemistry, specifically pH, total alkalinity, and TDS, should be examined. The pump output might exceed the filter's design flow rate, requiring a check of pump performance. Ineffective cleaning could also be the culprit, so clean or replace the filter cartridge as instructed.
  • K
    Kathleen RamosAug 26, 2025
    Why is there high pressure on start-up in my Jandy Water Filtration System?
    • P
      Patrick Jones IIAug 26, 2025
      High pressure at start-up in your Jandy Water Filtration System may be due to a few reasons. A small eyeball fitting in the Pool/Spa can cause this, and you should replace it with a larger diameter fitting. A partially closed valve on the return line could also be the issue; check and fully open all valves on the return line. It's also possible the pump is too large, so verify the pump and filter selection. Lastly, dirty filter cartridges can lead to high pressure, so clean them as per the instructions.
  • K
    kelleranthonySep 1, 2025
    How to stop dirt returning to pool from Jandy Versa-Plumb CL 460?
    • K
      Kirsten JonesSep 1, 2025
      If dirt returns to the pool from your Jandy Water Filtration System, it could be due to a hole in the filter cartridge, requiring you to replace the filter cartridge as per the instructions. Alternatively, a worn o-ring seal inside the filter might be the cause, in which case you should replace the o-ring.

Summary

Safety Information

Important Safety Warnings

Critical warnings on pressure limits, air hazards, and system connections.

General Safety Instructions

Guidelines for installers and operators regarding safe use and servicing.

General Information

Introduction to Cartridge Filters

Overview of the manual's purpose and contact information.

Filter Description and Function

Explains how cartridge filters operate and filter debris.

General Installation Requirements

Lists essential requirements for filter placement and installation.

Specifications and Dimensions

Provides technical data and physical measurements for filter models.

Installation Instructions

Filter Location Selection

Guidance on choosing an appropriate and safe location for the filter.

Anchor Bracket Installation

Steps for securing the filter to the equipment pad using anchor brackets.

Filter Preparation Steps

Procedures for inspecting and preparing the filter before installation.

Filter Plumbing Procedures

Clamp Installation

Start-Up and Operation

Filter Disassembly and Assembly

Maintenance

General Maintenance

Routine tasks to keep the filter in good working order.

Pressure Gauge Monitoring

Importance of monitoring the pressure gauge and checking for leaks.

Filter Cartridge Cleaning

Method for effectively cleaning the filter cartridges.

Troubleshooting Guide

Parts List and Exploded View

Jandy CL and CV Cartridge Filter Parts List

Comprehensive list of all replaceable parts with model and part numbers.

Jandy CL and CV Filters Exploded Diagrams

Visual exploded views of the CL and CV filter models for part identification.

Head Loss Curves

Jandy CL and CV Cartridge Filter Design Head Loss Curves

Charts showing design head loss versus flow rate for different filter models.

Limited Warranty Information

Jandy Versa-Plumb CL 460 Specifications

General IconGeneral
ModelCL 460
BrandJandy
CategoryWater Filtration Systems
TypeCartridge Filter
Filtration area460 sq ft
Flow Rate150 GPM
Cartridge Quantity1
Maximum Operating Pressure50 PSI
Cartridge MaterialPolyester

Related product manuals