Jandy WaterColors - To Operate the Light and Change Colors; Wiring to a Switch; Section 5. Jandy Watercolors RGBW LED Light Operating Instructions; Wiring to a Time Clock

Jandy
®
WaterColors RGBW LED Lights | Installation & Operation Manual ENGLISH
Page 7
4.2 Wiring to a Time Clock
The Jandy WaterColors RGBW LED Lights can be
wired into a basic time clock to automatically turn on
the lights at a predesignated time. Refer to Figure 4
toconnect the lights into the time clock.
4.3 Wiring to a Switch
The Jandy WaterColors RGBW LED Lights can be
wired into a switch to manually turn on/off the lights.
Refer to Figure 5 to connect the lights into the switch.
Section 5. Jandy WaterColors
RGBW LED Light
Operating Instructions
5.1 To Operate the Light and Change
Colors
Turn the light ON. The first time the light is turned
on, the color sequence begins with the Alpine White.
To change the color, turn the light OFF and then ON
within three (3) seconds. Continue turning OFF and
ON until the desired light color mode is reached.
See Table 1 for the color mode sequence.
Sequence
Order
Color Modes
1 Alpine White
2 Sky Blue
3 Cobalt Blue
4 Caribbean Blue
5 Spring Green
6 Emerald Green
7 Emerald Rose
8 Magenta
9 Violet
10 Slow Color Splash
11 Fast Color Splash
12 America the Beautiful
13 Fat Tuesday
14 Disco Tech
Table 1. Jandy WaterColors Lights Sequence
NOTE: When the light is turned OFF for more than seven (7)
seconds, it will remain in the color set that is currently
active. When the light is turned back ON, the light will be
on the same color set.
120V
LED
Light
Black
White
Green
Black
White
Green
Junction
Box
Ground
Ground
GFCI
Neutral
120 VAC
Power Supply
Line 1
Load 1
Line 2
Load 2
Filter Pump Relay Aux. 3 Relay
Optional
Optional
Optional Optional
24 VAC
Secondary
Primary
Figure 2. 120-Volt Jandy WaterColors RGBW LED Light
Wiring Diagram
120V
LED
Light
Black
White
Green
Black
White
Green
Junction
Box
Neutral
Ground
120 VAC
Power Supply
Line 1
Load 1
Line 2
Load 2
Filter Pump Relay Aux. 3 Relay
Optional
Optional
Optional Optional
24 VAC
Secondary
Primary
Black
White
Green
120V/12V
Transformer
GFCI*
* If required by transformer manufacturer's instructions or by local code and
AHJ requirements.
Figure 3. 12-Volt Jandy WaterColors RGBW LED Light
WiringDiagram