m
Product Description
Operating concept
You can program the UMG604 and call up
measured values in several ways.
Directly• at the device using 2 keys and the
display. You can change the values in the
parameter list (see Appendix) and call up
the measured values from the measured
value displays.
Via the • GridVis programming software.
In devices with an ethernet interface, via •
the homepage of the UMG604.
Via the RS485 with the • modbus protocol.
You can change and call up data with the
help of the modbus address list (is filed on
the enclosed data carrier).
Operation of the UMG604 via the integrated
display and the two keys only is described in
these operating instructions.
The Gridvis programming software and the
homepage have their own “online help”.
Methods of measurement
The UMG604 measures continuously and
calculates all effective values over a 200 ms
interval.
Use the parameter list in the
appendix to these instructions for
programming at the UM G604 and
the modbus address list on the
data carrier included in the scope of
supply for programming via a serial
interface.
To Next Page
Loading...
Need help?
General
