ANNEX
SETTING POSITIONS OF SL/DF DIALS
e
7. Check and make sure if a shaft "i" is parallel to a shaft "h". Fasten a screw "j".
(See Fig. 2&3)
8. Check and make sure if gear shifting levers engage gears inside of SL/DF dials
as shown in Fif. 4. " A " shows the position where a tool " A " gose through.
9. Check and make sure if the hook of the looper follower "c" falls into the V-shaped
hollow of the upper looper shifting cam "b". (See adjustment of the page F "POSITION
OF THE PDISPLAY DRUM INDICATOR & UPPER LOOPER SHIFTING CAM" and
view A ). Tighten screw "a".
10. If stopper spring plate "p" gives too heavy or light pressure on SL dial, loosen screw "n"
and adjust the position of stopper spring plate by sliding upper or lower. Tighten screw
"n". (See Fig. 3)
52
To Next Page
