Janome 15 - Sewing Machine Setup; Connecting to Power

5
SECTION 2. GETTING READY TO SEW
Connecting the Power Supply
z Turn the power switch off.
x Insert the machine plug into the machine
socket.
c Insert the power supply plug into the wall
outlet.
v Turn the power switch on.
q Power switch
w Machine plug
e Machine socket
r Power supply plug
t Wall outlet
NOTE:
• Before connecting to the power supply,
make sure the voltage shown on the
machine conforms to your electrical power.
• Before using your sewing machine for the
rst time, place a scrap of fabric under
the presser foot and run the machine with
thread for a few minutes. Wipe away any oil
which may appear.
WARNING:
While in operation, always keep your eyes
on the sewing area, and do not touch any
moving parts such as the thread take-up lever,
handwheel or needle.
Always turn off the power switch and unplug
from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control,
otherwise the machine will run intermittently.
q
w
e
r
t
Operating Instructions:
The symbol "O" of a switch indicates the "off"
position of a switch.
For an appliance with a polarized plug (one blade
wider than the other):
To reduce the risk of electrical shock, this plug is
intended to t in a polarized outlet only one way.
If it does not t fully in the outlet, reverse the plug.
If it still does not t, contact a qualied electrician
to install the proper outlet. Do not modify the plug
in any way.
The foot controller Model YC-482J or TJC-150 is
used with this sewing machine (USA market only).
z v
x
c