Janome 2018 - Default Chapter; Table of Contents

CONTENTS
LOCATE AND IDENTIFY THE PARTS ................................................................. 1
WIND THE BOBBIN .............................................................................................. 2
PREPARE YOUR TOP THREAD .......................................................................... 3
STITCH SELECTOR / STITCH LENGTH / STITCH WIDTH CONTROLS ............ 4
WHAT TO DO WHEN ............................................................................................ 5-7
SERVICE ACCESS
FACE COVER ...................................................................................... 8
FRONT COVER.................................................................................... 9
REAR COVER ...................................................................................... 10
MECHANICAL ADJUSTMENT
TOP TENSION ..................................................................................... 11
BOBBIN TENSION ............................................................................... 12
PRESSER BAR HEIGHT AND ALIGNMENT ....................................... 13
NEEDLE SWING .................................................................................. 14
NEEDLE DROP .................................................................................... 15
CLEARANCE BETWEEN NEEDLE AND HOOK (NO.1)...................... 16
CLEARANCE BETWEEN NEEDLE AND HOOK (NO.2)...................... 17
FEED DOG HEIGHT ................................................................................ 18
NEEDLE BAR HEIGHT ........................................................................ 19
NEEDLE TIMING TO SHUTTLE .......................................................... 20
DISTORTED PATTERN ....................................................................... 21
BUTTONHOLE FEED BALANCE ......................................................... 22
BARTACK FEED OF BUTTONHOLE................................................... 23
BUTTONHOLE FUNCTION.................................................................. 24
DISENGAGEMENT OF CAM FOLLOWER .......................................... 25
MOTOR BELT TENSION ..................................................................... 26
WIRING .............................................................................................................. 27
OILING .............................................................................................................. 28
SPECIAL TOOLS REQUIRED .............................................................................. 29