Janome 2018 - Feed Dog Height

18
GAUGE FEED DOG HEIGHT
FACE (A) FACE (B) (RED)
1.25MM 1.00MM
NOT MOVING MOVING CORRECT
NOT MOVING NOT MOVING LOW
MOVING MOVING HIGH
(B)
(C)
(A) #68367
MECHANICAL ADJUSTMENT
FEED DOG HEIGHT
MACHINE SETTING
1. STITCH LENGTH: SET AT 4.
2. NEEDLE BAR: AT ITS HIGHEST POSITION.
TO CHECK:
1. RAISE THE PRESSER FOOT.
2. PLACE THE FEED DOG HEIGHT GAUGE #68367 (A) ON THE NEEDLE PLATE.
3. TURN THE HANDWHEEL TOWARD YOU BY HAND, AND CHECK THE FEED DOG
HEIGHT. (REFER TO CHART BELOW.)
ADJUSTMENT PROCEDURE:
1. OPEN THE SHUTTLE COVER.
2. LOOSEN THE SCREW, (B) AND TURN THE ECCENTRIC PIN (C) IN EITHER
DIRECTION TO ADUST THE FEED DOG HEIGHT AS REQUIRED.
3. TIGHTEN THE SCREW (B) SECURELY.