24
MECHANICAL ADJUSTMENT
BUTTONHOLE FUNCTION (2049, 2041)
TO CHECK:
BUTTONHOLES SHOULD BE ABOUT 3MM LONGER THAN THE LENGTH SET BY THE R
FOOT. IF THIS LENGTH CANNOT BE OBTAINED, THEN CHECK AND ADJUST AS
FOLLOWS:
ADJUSTMENT PROCEDURE:
1. REMOVE THE FACE COVER. (SEE PAGE 8)
2. TURN THE ADJUSTING SCREW IN THE DIRECTION OF (A) IF THE BUTTONHOLE
LENGTH IS LONGER THAN THE STANDARD, OR IN THE DIRECTION OF (B) IF THE
BUTTONHOLE LENGTH IS SHORTER THAN THE STANDARD.
3. ATTACH THE FACE COVER.
(A)
(B)
ADJUSTING
SCREW
BUTTONHOLE
LEVER
STANDARD
ABOUT 3MM
To Next Page
Loading...
