Janome 415 - Stitch Pattern, Length, and Width Controls

12
Slide the stitch width control to set the setting mark at the
desired stitch length.
The higher the number, the longer the stitch
Setting mark
Pattern Selector Dial
Stitch Length Control
" " is the recommended setting for buttonhole stitching.
Adjust the stitch length control in the 0.5–4 range when
you sew the zigzag stitch.
Set the stitch length control at "S.S." to sew the stretch
stitch pattern sewing.
If the stretch stitch pattern is uneven, slide the stitch length
control in the direction of "–" to compress it, or "+" to expand
it.
Stitch Width Control
Note : Raise the needle above the fabric, when you turn
the stitch width dial.
1
1
1
S.S.
Raise the needle and presser foot. Turn the pateern
selector dial to set the setting mark at the symbol
corresponding to the desired pattern.
Slide the stitch width control to set the setting mark at
the desired stitch width.
The higher the number, the wider the stitch width
Setting mark
1
1
1
Setting mark
1
4
2
3
A
C
D
E
F
G
H
01234S.S.
012345
01234S.S.
1
4
2
3
AACDEFGH
AACDEFGH
When the stitch width is narrow, the right side of the pattern
is cut off.
(Example:Pattern E)
Width [5] Width [3]