Janome 415 - Sewing on Buttons

19
Sewing on Buttons
1
2
3
Pattern selector: C
Presser foot: Zigzag foot
Thread tension: 1–3
Stitch length: Any
Stitch width: Adjust as necessary
Feed dog: Dropped
4
1
2
3
5
4
5
6
C
6
1 2
3
4 5
1 Push the drop lever to the left to lower the feed dog.
Set the pattern selector dial at "C" and stitch width control
at 0.
Place the button under the foot. Unthread the needle and
turn the handwheel slowly to lower the needle into the left
hole on the button.
Align the right hole on the button with the slot of the foot
and lower the foot to hold the button in place.
2 Raise the needle and adjust the stitch width so that the
needle enters into the right hole on the button.
3 Rethread the needle and sew 10 stitches. A pin can
be placed on top of the foot to form a shank
.
4 Raise the needle and set the stitch width control to 0
then sew a few stitches to lock the seam.
5 Raise the foot and trim the excess thread.
Note: When button sewing is finished, raise the feed dog.
1
4
2
3
A
C
D
E
F
G
H
01234S.S.
012345