Janome 5060QDC - SECTION II. GETTING READY to SEW Connecting the Power Supply; Before Using Your Sewing Machine

4
q
t
e
r
u
y
w
i
e
t
r
w
q
SECTION II. GETTING READY TO SEW
Connecting the Power Supply
• Using the foot control
Turn off the power switch q.
Insert the foot control plug w into the foot control jack e.
Insert the machine plug r into the power inlet t.
Insert the power supply plug y into the wall outlet u.
Turn on the power switch q.
The foot control sign i will be displayed when the foot
control is connected to the machine.
q Power switch
w Foot control plug
e Foot control jack
r Machine plug
t Power inlet
y Power supply plug
u Wall outlet
i Foot control sign
• Using the start/stop button
Turn off the power switch q.
Insert the machine plug w into the power inlet e.
Insert the power supply plug r into the wall outlet t.
Turn on the power switch q.
q Power switch
w Machine plug
e Power inlet
r Power supply plug
t Wall outlet
NOTE:
The start/stop button does not work when the foot
control is connected.
WARNING:
While in operation, always keep your eyes on the
sewing area and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control, otherwise
the machine will run inadvertently.
Before Using Your Sewing Machine
Before using your sewing machine for the rst time,
place a scrap of fabric under the presser foot and run the
machine without thread for a few minutes. Wipe away
any oil which may appear.