Need help?Do you have a question about the Janome 5100 and is the answer not in the manual?
General| Stitch Options/Count | 100 |
|---|---|
| Buttonhole Styles | 7 |
| Needle Position | Variable |
| Foot Control | Yes |
| Speed Control Slider | Yes |
| Start/Stop Button | Yes |
| Maximum Stitch Width | 7 mm |
| Maximum Stitch Length | 5 mm |
| Drop Feed | Yes |
| Free Arm | Yes |
| Sewing Speed | 820 stitches per minute |
| Needle Threader | Built-in |
Troubleshooting needle skipping issues with causes and fixes.
Troubleshooting fabric feeding problems with causes and fixes.
Adjusting the distance between the presser foot and needle plate to 6.0 mm.
Adjusting the needle drop position and clearance for optimal sewing.
Adjusting the hook timing for proper needle and hook interaction.
Adjusting the needle bar height based on hook timing.
Adjusting clearance between needle and hook tip (-0.1 to +0.05 mm).
Adjusting the feed dog height to 0.80-0.90 mm from the needle plate.
Adjusting top tension to be between 65 and 80 grams.
Checking and adjusting stretch stitch feed balance for proper pattern formation.
Adjusting the buttonhole lever guide and sensor position for correct operation.
Testing the DC motor for proper operation.
Procedure for removing and replacing the driving motor (DC motor).
To Next Page