13
The highest position of the feed dog should be between 0.80 and 0.90 mm from the surface of the needle
plate.
1. Lower the presser foot and turn the power switch on.
2. Turn the handwheel toward you to set the feed dog at the highest position.
3. Remove the free-arm cover. (See page 5.)
4. Loosen the setscrew q and nut w.
5. Adjust the feed dog height by turning the adjusting screw e.
The highest position of the feed dog should be between 0.80 and 0.90 from the surface of the needle plate.
6. Tighten the nut w and setscrew q.
7. Attach the free-arm cover.
FEED DOG HEIGHT
MECHANICAL ADJUSTMENT
A B
e
w
Presser foot
Feed dog
0.80 – 0.90 mm
Surface of the needle plate
q
To Next Page
Loading...
