Janome 521 - Inserting the Bobbin

24
Inserting the bobbin
z Place the bobbin in the bobbin holder with the thread
running off as illustrated.
q Thread
x Guide the thread into the front notch on the front side
of the bobbin holder. Draw the thread to the left,
sliding it between the tension spring blades.
w Front notch
e Tension spring blade
c Continue to draw the thread lightly until the thread
slips into the side notch.
r Side notch
v Pull out about 4” (10 cm) of thread. Attach the hook
cover plate. Check the threading by referring to the
chart shown on the hook cover plate.
t Thread
y Hook cover plate
q
w
e
r
t
y
z
x
c
v