26
Threading the Machine
To set the needle thread:
Raise the thread take-up lever to the highest position by
turning the handwheel.
Raise the presser foot.
z Draw the thread from the spool and pass it under the
thread guide. Then draw it down along the right
channel.
q Thread guide
w Right channel
x Draw the thread up around the bottom of the thread
guide plate.
Pull the thread up along the left channel
e Thread guide plate
r Left channel
c Firmly draw the thread from right to left over the
thread take-up lever and down into the take-up lever
eye.
t Thread take-up lever
v Draw the thread down along the left channel and slip
the thread behind the needle bar thread guide from
the left.
y Needle bar thread guide
b Pass the thread through the needle eye from the front
or use the needle threader (refer to the next page).
z
x
c
b
v
q
w
e
r
t
y
z
x
c
v
b
To Next Page
Loading...
