18
¥
Adjusting the Stitch Length
The LED display shows Ò 2.2 Ó (default setting) when the
plus or minus key is pressed once.
Press the plus (+) key to increase stitch length.
Press the minus (Ð) key to decrease stitch length.
The stitch length can be varied from 0.0 to 5.0.
NOTE: Reverse stitch length cannot be set longer than
2.5.
¥
Changing the needle drop position
You can change the needle drop position of straight
stitching, i.e. patterns #01-03 and #06-09.
The LED display shows Ò 3.5 Ó (default setting), which
represents the center needle position when the plus or
minus key is pressed once.
Press the plus (+) key to move the needle to the right.
Press the minus (Ð) key to move the needle to the left.
Left needle position
Center needle position
Right needle position
1 2 3
1
2
3
(1.0) (2.2) (5.0)
To Next Page
Loading...
