Chaining Finger Switch Knob Adjustment
(Changing to Standard Serging or Rolled
Hemming)
Standard serging
The chaining finger is located beside the needle plate.
Turn the chaining finger switch knob to “S” for standard
serging.
q Chaining finger
w Chaining finger switch knob
Rolled hemming
Turn the chaining finger switch knob to “R” for rolled for
hemming, picot edging or narrow hemming sewing.
q Chaining finger
w Chaining finger switch knob
CAUTION
Turn the power switch OFF before adjusting the
chaining finger switch knob.
q
q
w
w
q
w
e
The chaining finger switch knob is connected to the
chaining finger.
The chaining finger slides back and forth when you set
the chaining finger switch knob to “S” or “R”.
Turn the handwheel toward you to match the “ ” mark on
the belt cover with the “–” mark on the handwheel.
q Handwheel
w “ ” mark
e “–” mark
13
To Next Page