Janome DC6030 - Presser Foot Operations; Presser Foot Lifter; Changing the Presser Foot; Foot Holder Operations

10
Lower shaft gear
Hexagonal socket screw
The amount of ascending travel of the needle bar from its lowest position to the position ( ) where the tip of the
rotary hook exactly meets the right side of the needle should be 3.25 to 3.55 mm.
1. Remove the needle plate and bobbin holder.
2. Remove the free-arm cover.
3. Turn the power switch on. Select the pattern (left position). Set the zigzag width at 0.
4. Turn the handwheel toward you to lower the needle at its lowest position.
5. Loosen the hexagonal socket screw (2 pcs.).
6. Move the needle bar 3.4 mm from the lowest position.
7. Turn the lower shaft gear until the tip of hook meets the right side of the needle while holding the handwheel.
8. Tighten the hexagonal socket screw (2 pcs.).
9. Attach the free-arm cover, bobbin holder and needle plate.
Adjustment of Hook Timing
Needle plate
Bobbin holder
Left position
(#14)
Tip of hook meets the
right side of the needle
Lowest needle position
3.25 – 3.55mm
Hexagonal socket screw