Janome DC6030 - Needle and Threading; Changing the Needle; Selecting Thread and Needles

14
Feed Dog Adjustment
The highest position of the feed dog should be parallel to the surface of the needle plate.
If not, adjust as follows.
1. Use a hexagonal socket screw (4 x 6).
Insert the screw to the hole (B). Tighten the hexagonal socket screw as far as it goes.
2. Loosen the setscrew (C).(left screw)
3. Turn hexagonal socket screw to adjust the feed dog (should be parallel to the surface of the needle
plate).
4. Tighten the setscrew (C).(left screw)
5. Loosen the hexagonal socket screw and remove it.
Setscrew (C)
Setscrew (C)
(left screw)
Hexagonal socket scrw 4 x 6
Hole (B)