16
Inserting the Bobbin
z Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
x Guide the thread into the front notch on the bobbin
holder.
1 Front notch
c Draw the thread to the left, sliding it between the
tension spring blades.
2Tension spring blades
v Continue to draw the thread lightly until the thread
slips into the side notch.
3 Side notch
b Pull out about 10 cm (4") of thread to the rear.
Reattach the hook cover plate.
4 Hook cover plate
NOTE:
The threading chart is shown on the hook cover plate
for your reference.
z
c
x
1
2
3
b
v
4
To Next Page
Loading...
