18
Replacing the Foot Holder
Replace the foot holder, if you use the dual feed feet,
darning foot or embroidery foot.
CAUTION:
Press the lockout key to lockout the machine before
replacing the foot holder.
Removing the presser foot holder
Raise the needle by pressing the needle up/down button.
Press the lockout key and raise the presser foot with the
presser foot lifter.
q Lockout key
w Presser foot lifter
Loosen the thumbscrew and remove the presser foot
holder.
e Thumbscrew
NOTE:
Use the foot holders included in the standard accessories
only.
Attaching the dual feed holder
Attach the dual feed holder to the presser bar.
q Dual feed holder
Tighten the thumbscrew with your figers.
Push the dual feed link to engage it with upper feed drive.
w Dual feed link
e Upper feed drive
Lower the presser foot lifter. Lower the needle to the
lowest position by turning the hand wheel.
Tighten the thumbscrew securely with the screwdriver.
q
w
q
e
w
e
w
To Next Page
Loading...
