Need help?Do you have a question about the Janome JUNO E1015 and is the answer not in the manual?
General| Stitch Options | 15 |
|---|---|
| Maximum Stitch Width | 5 mm |
| Maximum Stitch Length | 4 mm |
| Foot Control | Yes |
| Adjustable Stitch Length | Yes |
| Adjustable Stitch Width | Yes |
| Reverse Stitch | Yes |
| Drop Feed | Yes |
| Free Arm | Yes |
| Weight | 5.5 kg |
| Included Feet | Zipper foot, Buttonhole foot |
Discusses issues with stitches not forming correctly, their causes, and remedies.
Covers problems with fabric feeding and potential solutions.
Details common causes and remedies for upper thread breakage during sewing.
Explains issues leading to bobbin thread breakage and corrective actions.
Addresses causes for needle breakage and recommended solutions.
Identifies causes of machine noise and methods for correction.
Explains reasons for incorrect stitch patterns and how to fix them.
Instructions for removing and attaching the machine's face cover.
Guidance on removing and attaching the machine's base plate.
Procedure for removing and reattaching the front cover of the sewing machine.
Steps for removing and reattaching the rear cover of the sewing machine.
Adjusting the top thread tension for proper stitch formation.
Procedure for checking and adjusting the bobbin thread tension.
Steps to set the correct height and alignment of the presser bar.
Adjusting the needle's sideways movement for zigzag stitching.
Adjusting the needle's vertical position relative to the hook.
Method 1 for adjusting the needle-to-hook clearance.
Method 2 for adjusting the needle-to-hook clearance when Method 1 is insufficient.
Adjusting the height of the feed dogs for proper fabric feeding.
Adjusting the vertical position of the needle bar.
Setting the correct timing between the needle and the shuttle hook.
Adjusting feed balance for consistent buttonhole stitches.
Adjusting feed balance for proper stretch stitch formation.
Adjusting feed direction for bartack sewing on buttonholes.
Adjusting clearance for smooth pattern selection during bartack sewing.
Adjusting the tension of the motor drive belt.
To Next Page