15
1
• Threading the Lower Looper
Open the looper cover and side cover.
Place the spool of thread on the right side spool pin.
* The points to thread for lower looper are marked
in green.
* A convenient threading chart is placed on the
machine body inside the looper cover.
1. Draw the thread through the right side thread
guide from back to front: (A)
* If the thread is coming out from the thread guide
groove, pass the thread through the thread guide
hole again as shown: (B)
1
Thread guide
2. Pass the thread through the holes on the right side
of the thread guide plate as illustrated.
2
Thread guide plate
3. Pass the thread through the right side of the
looper thread guide, sliding the thread from left to
right.
3
Looper thread guide
1
2
3
1
2
3
5
6
7
8
9
11
2
3
(A) (B)
10
4
To Next Page
Loading...
