Janome Memory Craft 9850 - Machine Operating Buttons; Primary Operation Buttons

8
q
w
e
r
t
Machine Operating Buttons
q Start/stop button
3UHVVWKLVEXWWRQWRVWDUWRUVWRSWKHPDFKLQH
7KHPDFKLQHVWDUWVUXQQLQJVORZO\IRUWKHÀUVWIHZ
stitches, it then runs at the speed set by the speed control
VOLGHU7KHPDFKLQHUXQVVORZO\DVORQJDVWKLVEXWWRQLV
SUHVVHG
The button will turn red when the machine is running, and
JUHHQZKHQLWKDVEHHQVWRSSHG
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
WKHEXWWRQLVUHOHDVHG
NOTES:
7KHVWDUWVWRSEXWWRQFDQQRWEHXVHGZKHQWKHIRRW
FRQWUROLVFRQQHFWHGWRWKHPDFKLQH
<RXFDQVHOHFWWKHGHVLUHGVWDUWXSVSHHGIURP
VORZQRUPDORUKLJKUHIHUWRSDJH
w Reverse button
When sewing stitch pattern U1, U4, U9, U10, Q1-Q3 or
BR1-5, the machine will sew in reverse as long as the
UHYHUVHEXWWRQLVSUHVVHG
If stitch pattern U1, U4, U9, U10, Q1-Q3 or BR1-5, has
been selected and the foot control is not connected,
the machine will start sewing in reverse as long as the
UHYHUVHEXWWRQLVSUHVVHG
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
VWLWFKHVDQGDXWRPDWLFDOO\VWRS
e Auto-lock button
When sewing stitch pattern U1, U4, U9, U10, Q1-Q3 or
BR1-5, the machine will immediately sew locking stitches
and automatically stop when the auto-lock button is
SUHVVHG
When sewing all other patterns, the machine will sew to
the end of the current pattern, sew locking stitches and
VWRSDXWRPDWLFDOO\
The machine will trim the threads automatically after
locking the stitch when “Thread Cut after Auto-Lock”
RSWLRQLVWXUQHGRQUHIHUWRSDJH
r Needle up/down button
3UHVVWKLVEXWWRQWREULQJWKHQHHGOHEDUXSRUGRZQ
7KHPDFKLQHZLOOVWRSZLWKWKHQHHGOHLQGRZQSRVLWLRQ
However, you can change the needle stop position in the
VHWWLQJPRGHUHIHUWRSDJH
NOTE:
The LED signal y is turned on when the down position
LVVHOHFWHGDQGYLFHYHUVD
t Thread cutter button
3UHVVWKLVEXWWRQZKHQ\RXÀQLVKVHZLQJWRWULPWKH
WKUHDGV7KHQHHGOHEDUDXWRPDWLFDOO\ULVHVDIWHUWULPPLQJ
WKHWKUHDGVUHIHUWRSDJH
NOTES:
7KH/('VLJQDOu blinks when the machine trims
WKUHDGV
7KH/('VLJQDOu turns on when “Thread Cut
after Auto-Lock” is ON in setting mode (refer to page

8VHWKHWKUHDGFXWWHURQWKHIDFHFRYHULIWKHWKUHDG
 LVRUWKLFNHU
u
y