Janome Memory Craft 9850 - Checking Pattern Combination Length

54
Startover key
This is a 2-way function key to start sewing a pattern
FRPELQDWLRQRYHUIURPWKHEHJLQQLQJ
When you stop sewing a pattern combination, the
VWDUWRYHUNH\LVDFWLYDWHG
The key shows a triangle and single bar that means the
PDFKLQHZLOOVWDUWRYHUIURPWKHFXUUHQWSDWWHUQ
When you press the startover key, the key will change
and show a triangle and double bar that means the ma-
FKLQHZLOOVWDUWRYHUIURPWKHÀUVWSDWWHUQRIWKHFRPELQD-
WLRQ
Current pattern startover
If you wish to start sewing from the beginning of the cur-
rent pattern, press the startover key once and start the
PDFKLQH
q
Startover key (current pattern)
w
Current pattern
First pattern startover
,I\RXZLVKWRVWDUWVHZLQJIURPWKHEHJLQQLQJRIWKHÀUVW
pattern of the combination, press the startover key twice
DQGVWDUWWKHPDFKLQH
e
 6WDUWRYHUNH\ÀUVWSDWWHUQ
r
First pattern
NOTE:
If auto thread cutting is done, the machine will startover
IURPWKHÀUVWSDWWHUQ
Checking pattern combination length
You can check the total length of the pattern combination
by pressing the pattern combination key w indicated in
WKHPDQXDOVHWWLQJZLQGRZ7RHQWHUWKHPDQXDOVHWWLQJ
ZLQGRZSUHVVWKHDGMXVWNH\q
The readout of the total length is a theoretical value
and the actual length may vary depending on sewing
FRQGLWLRQV
For example, program pattern P1 three times, and sew a
SDWWHUQFRPELQDWLRQ
If the actual length differs considerably from the readout,
measure the actual length and enter the nearest value by
pressing the
“
+
”
or
“‒”
NH\
e
Actual length
7KHUHDGRXWLVDGMXVWHGDXWRPDWLFDOO\ZKHQFDOFXODWLQJ
the length of other pattern combinations (combination of
SDWWHUQV3;IRUH[DPSOH
q
e
e
w
w
r
q
w