Janome Memory Craft 9850 - Inserting the Bobbin

12
z
x
c
v
Inserting the bobbin
z 3UHVVWKHORFNRXWNH\
Place a bobbin in the bobbin holder with the thread
running off counterclockwise as shown on the hook
FRYHUSODWH
q End of thread
w Bobbin holder
e Hook cover plate
x+ROGWKHEREELQZLWKÀQJHUWLSVRLWGRHVQRWURWDWH
Guide the thread into the front notch of the bobbin
KROGHU
  3XOOWKHWKUHDGWRWKHOHIWWRSDVVLWXQGHUWKHJXLGH
r Front notch
t Guide
c Draw the thread to the left to pass it into the guide
SDWKPDUNHG´µ
Make sure that the thread comes out from the side
QRWFKRIWKHEREELQKROGHU
y Guide path 1
u Side notch
NOTE:
If the thread does not come out from the side notch,
rethread from step z
v Continue to draw the thread along the guide path
marked “2” and pull the thread to the right through the
VOLW7KHWKUHDGZLOOEHFXWWRDSURSHUOHQJWKDQGKHOG
LQSODFH
i Guide path 2
o Slit (Thread cutter)
wq
e
r
t
y
Correct
u
u
u
Wrong
i
o
b
!0
b 6HWWKHOHIWHGJHRIWKHKRRNFRYHUSODWHLQWRRSHQLQJ
  3XVKGRZQWKHKRRNFRYHUSODWHWRÀWLQSODFH
!0 Hook cover plate
NOTE:
Unless otherwise noted, you can start sewing without
GUDZLQJXSWKHEREELQWKUHDG
Refer to page 15 for how to draw up the bobbin
WKUHDG