29
n The buttonhole is sewn in the sequence as shown.
When the buttonhole is nished, the machine will stop
automatically with the needle in the up position.
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is nished, do not raise the foot or
buttonhole lever, simply start the machine again.
n
m
,
!0
!1
m Remove the fabric and place a pin just below the
bartack to prevent accidentally cutting the stitches.
Cut the opening with the seam ripper.
!0 Pin
!1 Seam ripper
, When buttonhole sewing is nished, push the
buttonhole lever upward as far as it will go.
y Buttonhole lever
y
NOTE:
If the fabric is not feeding smoothly when sewing
a double layer buttonhole, increase the buttonhole
density (refer to page 30).
To Next Page
Loading...
